Mould Clamp

CG Clamp features mechanical locking system. The holder of clamp can be shrunk into the clamp when unclamping. It can avoid interference between the holder and mold template.
It is only applied on Mold Changer System.

Send Inquiry

Product Introduction

MODEL CG

product-338-318

CG Clamp features mechanical locking system. The holder of clamp can be shrunk into the clamp when unclamping. It can avoid interference between the holder and mold template.
It is only applied on Mold Changer System.

MODEL SELECTION

CG - 1 B - 2 - 3 - 4
1	The capacity of clamp	4~50 tons
2	Thickness of template (H±0.5mm)
3	The direction of piping and wiring connection	L: on the left side R: on the right side U: on the upper side
4	Sensor voltage	3: DC10~30V (NPN, 3-Wire) 4: DC10~30V (PNP, 3-Wire)

INSTRUCTION OF SPECIFICATION

Model		CG-4B	CG-6B	CG-10B	CG-16B	CG-25B	CG-50B
Clamping force	tons	4	6	10	16	25	50
Retaining force	tons	0.8	1.2	2	3.2	5	10
Preserved stroke (Z)	mm	1.5		2
Working temperature	℃	Max 70℃

* Hydraulic Pressure: 13.7 Mpa (140kg/cm2) (2000psi)

* No hydraulic pressure

CG-4B~10B

product-353-245

product-361-251

CG-16B~50B

product-339-235

product-335-232

Model	A	B	C	D	E	F	G	I	J	L	M	N	O	P	Q	Rc	H±0.5	T
CG-4B	186	123	75	50	30	113	42	17	2	90	62	35	14	-	115	1/4	25	M16x32D
CG-6B	202	140	85	48	36	126	48	19	3	110	76	45	17	-	124	1/4	30	M20x40D
CG-10B	215	150	98	53	42	138	56	23	3	135	95	50	20	-	131	1/4	30	M24x48D
CG-16B	258	190	128	74	53	175	82	28	5	138	104	60	17	40	156	1/4	30	M20x40D
CG-25B	302	240	159	100	64	212	100	33	5	170	130	75	20	50	188	3/8	40	M24x48D
CG-50B	365	290	195	140	88	268	125	35	5	215	162	100	27	60	227	3/8	50	M33x65D

* H is the minimum size.

* When H increase, the size of Q will be increased accordingly.

Hot Tags: mould clamp, Taiwan mould clamp manufacturers, suppliers, factory, Air Clamp, Check Valve Clamp, Injection Mold Clamps, Mold Clamp, Mould Clamp, Quick Change Mold Clamps

Injection Mold Clamps

No Information