Products

The electro-permanent magnetic clamping plate/system for quick mold change system is perfectly for 50~4000 Tons injection molding machines.The latest magnetic structure and outstanding design of...

A lot of manpower and time are wasted when changing the mold on Press machine, which causes the production cost of the factory to increase and also reduces the production efficiency. After using...

The magnetic plate with electric permanent magnetic principle to design & manufacture. It only needs electrical energy at the moment of magnetization and demagnetization, the rest time no need...

Need be adjusted to let the back base making full contact with magnetic system. Remove the bulgy part, such as the edge of the dent, backplane landing angle extrusion highs, tighten the back plane...

When the mold back plate uneven or cavity, the clamping force of magnetic system will decrease because contact area decrease. HQMC magnetic system in the design process are usually considered...

As a leading manufacturer of Quick Mold Change System for Injection Molding Machines and Press Machines, SANDSUN’s magnetic mold clamping system significantly enhances the efficiency of mold...

Use 60T machine’s platen size as an example (left-right 480mm × up-down 46mm),the MIN platen size required is 250mm × 250mm. Because the limit size of the MIN platen is to prevent not enough...

Overload Protector is equipped in Press machine to check hydraulic pressure of cylinder inside the slider.
If happen overload, the hydraulic pressure of cylinder will be released immediately...

Overload Protector is equipped in Press machine to check hydraulic pressure of cylinder inside the slider.
If happen overload, the hydraulic pressure of cylinder will be released immediately...

Control unit: include air regulator, solenoid valve, air pressure gauge
We also customize special Overload Protector & oil tank, if required, please contact us directly.

Vents excess pressure in just 0.003 seconds.
Instantly triggers an electrical signal that activates the press’s emergency stop, preventing costly damage.
A built-in...

Releasing flow rate (Q) of overload protector, which you choose has to be more than of cylinder volume. If releasing flow rate isn't enough, please use two sets of overload protector.